Dental Service Mode

Optical RevEnge Dental oferă un mod de service care poate fi deschis din Tools Menu, pentru a recalibra și a diagnostica orice problemă care ar putea apărea.

Modul Live

Cu acest instrument este posibil să verificați vizualizarea live a camerelor scanerului.

Pentru a porni acest instrument, faceți clic pe butonul  ;

Verificați Scanerul

Software-ul verifică dacă conexiunea scanerului este în ordine de fiecare dată când este activată.

Cu ajutorul acestui instrument este posibilă rularea manuală a acestei verificări.

Recalibrați Capul

Pentru a lansa acest instrument, faceți clic pe butonul  ;

Există 2 tipuri de calibrare:

Recalibrare

procedură rapidă pentru a actualiza periodic calibrarea scanerului sau pentru a fi efectuată dacă scanerul este mutat în orice altă locație

Calibrarea completă

Procedura mai complexă trebuie efectuată după o reparație mecanică

Acest instrument utilizează setul Calibration Kit pentru a efectua o nouă calibrare a capului optic al scanerului. Procedura este următoarea:

1. Put the calibration kit inside the scanner in the correct position
2. Select the calibration type from the drop-down menu
3. In the calibration dialog, select from the drop down menu the exact calibration kit name
4. Click Start

If the calibration kit name is not available in the drop down menu, the Load New Master Xml button can be used to add a new calibration kit from the appropriate Xml description file.

The calibration procedure is automatic. Once finished, the software will show one of the following messages:

• 'Scanner Already Calibrated' : the calibration is not necessary
• 'Scanner Recalibrated Successfully' : the calibration has been completed
• 'Scanner Recalibration Failed' : calibration has to be repeated

If the calibration was successful, the Axes Calibration starts automatically.

Recalibrate Axis

This tool is used to check the movement system of the scanner. The scanner will scan an object, analyze it, and use this data to calibrate the movement system.

This tool will start automatically after a Head Recalibration or can be started manually with the button.

When the Dynamic Articulation Module is enabled, calibrate the axis with the specific Axis Calibration Object. From that moment on, any recalibration needs to be performed with the same object. Otherwise, axis recalibration will fail.

1. Put the calibration object inside the scanner
2. Click Recalibrate Axis
3. Click Ok when prompted

The calibration procedure is automatic. Once it is finished, the software will show one of the following messages:

• 'Axis Recalibration Successfull' : the calibration has been completed
• 'Axis Recalibration Failed' : calibration has to be repeated

Auto Set-Up Multi-Die Parameters

This tool is used to calibrate the Multi-Die support. If the acquisitions carried out with the Multi-Die are not correctly recognized, the calibration procedure is the following:

1. Clean the multi-die from excessive material or white powder, every single die position needs to be clearly separated from the others
2. Put the empty multi-die support inside the scanner
3. Start the tool with this button
4. Click Ok when prompted

Diagnostic Acquisition

When doubting the proper functioning of the scanner, this tool carries out a specific acquisition of the object currently inside the scanner.

The software then saves all the information in a "*.diag" file that can be sent to the OpticalRevEng Dental support to diagnose possible issues.

To start this tool click the button.