Alignment

From Open Tech Dental Wiki 4.0
Revision as of 19:33, 24 September 2015 by Scaierman (talk | contribs) (Created page with "Quando mais de um objeto é escaneado pelo escaner, a posição de cada item não está relacionada com a posição dos outros. A fim de trabalhar corretamente com os dados es...")
Jump to: navigation, search


Alinhamento

Quando mais de um objeto é escaneado pelo escaner, a posição de cada item não está relacionada com a posição dos outros. A fim de trabalhar corretamente com os dados escaneados, todas as aquisições precisam estar localizados no mesmo sistema de referência.

Firstly, the user has to identify an Acquisition that will be used as a reference for all the others. In the Structured Projects the software automatically carries out this procedure.

Every time a new information is acquired, it is necessary to align the new data to the Reference Acquisition or to another acquisition already aligned at the rest of the project

Every acquired information will have a specific Reference Acquisition. The Project Tree will show this relation, every child will be aligned to its parent node in the tree.

Direct Alignment

OpticalRevEng Dental can align the Acquisitions by itself. Just:

  1. Select from the Project Tree the element that has to be aligned to the rest of the project
  2. Click the Alignment Button in the Main Toolbar

The software will select the most appropriate reference item, analyze the selected acquisition and the reference item and try to identify the correct position of the selected item inside the reference item.
If no alignment can be identified by the software, a Manual Alignment will start.

Manual Alignment

The manual alignment starts every time the software can not complete a Direct Alignment or by holding Key shift.png when clicking the Alignment Button in the Main Toolbar

Interface

During the manual alignment, the interface will change.

Dental 2 5 manualAlignment.jpg

There are 4 different areas in this screen:

  • On the top left there is the reference object, which gives the reference position for all the project data
  • On the top right there is the moving object, that has to be moved from its current position and placed in the same reference system of all the other project data
  • On the bottom there are, at the same time, both the objects, so that the user can check the current position of the moving object
  • On the bottom right some options and a Numeric Report are available

Procedure

To manually align the elements:

  1. Rotate both the reference object and the moving object in the same point of view, until the parts in common are visible
  2. Click on the same point on both the objects
  3. Check in the 3D view below if the position is more or less correct (it's not necessary, at this stage, to find the perfect position)
  4. Click the Best Fit button on the right

If the two objects have enough common points, the software will find the best alignment between them. Visually check the alignment on the bottom 3D View or by reading the values in the Numeric Report.

If the alignment is good, click Ok to confirm the new position of the moving object.

If the alignment is not good enough, click the Reset button and start the alignment again.

Dental 2 5 manualAlignmentAnim.gif

Options

There are two options available during the manual aligment:

  1. Fine Alignment : by clicking Best Fit the software will try to move the moving object up to 1mm, to find a better alignment. This can create problems if the parts in common between the two objects are really small. With the option Fine Aligment enabled, the software will move the moving object not more than 0.1mm
  2. Ignore Normals : the objects have an inside and an outside. When the software looks for an alignment, it doesn't align the inside of one object with the outside of the other. To ignore the differences between inside and outside, flag the Ignore Normals option
Dental 2 5 wiz prev.png Homebutton.png Dental 2 5 wiz next.png