Dynamic Articulation Module
Dynamic Articulation Module permite utilizatorului să transfere poziția de masticare realizată în laborator cu un articulator real în echivalentul său virtual Exocad
Atunci când modulul de articulare dinamică este activat, utilizatorul are la dispoziție un set de 4 plăci de montare Mounting Plates și un Recalibration Object. Accessories- Dynamic Articulation Module
Înainte de a utiliza modulul pentru prima dată, este necesar să calibrați axa scanerului pentru a funcționa corespunzător cu simularea ocluziei.
Calibrați axa cu Axis Calibration Object . Din acel moment, orice recalibrare trebuie efectuată cu același obiect. În caz contrar, recalibrarea axelor va eșua.
- Put the calibration object inside the scanner
- Click Recalibrate Axis
- Click Ok when prompted
The calibration procedure is automatic. Once it is finished, the software will show one of the following messages:
- 'Axis Recalibration Successfull' : the calibration has been completed
- 'Axis Recalibration Failed' : calibration has to be repeated
The following step is to set the correct Articulator Type during the Project Creation.
In the Articulator section select:
- Matching models to scan the occlusion if there is no need to use the automatic positioning in Exocad's Virtual Articulator
- Articulator A to scan the Artex Articulator and to use the same in Exocad's Virtual Articulator
- Articulator S to scan the Sam Articulator and to use the same in Exocad's Virtual Articulator
- Articulator P to scan the Kavo Articulator and to use the same in Exocad's Virtual Articulator
- Articulator B to scan the Bioart Articulator and to use the same in Exocad's Virtual Articulator
- Articulator D to scan the Denar Articulator and to use the same in Exocad's Virtual Articulator
Proceed scanning the physical Articulator, accordingly to the previously made choice.
Remember then to scan the jaws on top of the appropriate mounting plates, as the software will remind.
