Wiz Introduction

Step-By-Step Wizard

When you work with a Structured Project OpticalRevEng Dental can provide you a wizard that will guide you from the first scanner acquisition to the export of the data.

Wizard Interface

When you enter in the Wizard Mode the software interface change:

• The Main Toolbar disappear
• Instead of the Project Tree you'll see a Wizard Steps list that will remind you about what you've already done and what you have to do next.
• On the Top Right corner of the application you'll see the Wizard itself that will guide you and that you can handle with 4 buttons
  1.  : To return to the previous wizard step
  2.  : To skip the current step
  3.  : To close the Step-By-Step Wizard and continue to work manually
  4.  : To confirm the current step and proceed to the next one

For the entire wizard all the other tools will be locked. All the interactions will pass by the Wizard Panel on the top right of the screen

Wizard Sequence

The sequence of wizard steps depends on the specific project you have to do. It follows this logic:

1. Acquire all the required data from the scanner
2. After every single acquisiton:
   1. Clean the acquisition from the support holder data
   2. Align the acquisition to the rest of the project and check the alignment if needed
   3. Automatically clean the duplicated informations and let the user clean additional unwanted data
3. Let the user check that all the information is aligned correctly
4. Generate the neede meshes
5. Align the implants
6. Export to the cad

You can now return to the Main Page or continue to the Wizard Acquisition.