Difference between revisions of "Man StartScreen/fr"
L.leonardi (talk | contribs) (Created page with "La touche {{Inline button|Dental 2 5 actionOptions.png}} démarre la Fenêtre Options.") |
L.leonardi (talk | contribs) (Created page with "== Initialisation du Projet ==") |
||
| Line 10: | Line 10: | ||
La touche {{Inline button|Dental 2 5 actionOptions.png}} démarre la [[Dental_Options|Fenêtre Options]]. | La touche {{Inline button|Dental 2 5 actionOptions.png}} démarre la [[Dental_Options|Fenêtre Options]]. | ||
| − | == | + | == Initialisation du Projet == |
This is the Start Screen that appears when the software is launched having already set a project in an ''Invoking Software'', for example if started from the Exocad DentalDB. | This is the Start Screen that appears when the software is launched having already set a project in an ''Invoking Software'', for example if started from the Exocad DentalDB. | ||
Revision as of 13:43, 29 January 2016
Démarrage
La Page de Démarrage est la première au démarrage du logiciel.
On peut en avoir deux. L’une quand l’utilisateur démarre le logiciel directement, l’autre quand le logiciel est démarré par un logiciel diffèrent qui a déjà le projet.
En tous cas, le logiciel démarre une procédure de Control du Système et il montre un message. Si le système fonctionne et le scanneur est branché correctement il y a le message de confirme Scanneur initialisé correctement. Si pour des raisons différentes le scanneur ne fonctionne pas, il y a un message d’erreur.
La touche 
démarre la Fenêtre Options.
Initialisation du Projet
This is the Start Screen that appears when the software is launched having already set a project in an Invoking Software, for example if started from the Exocad DentalDB.
On the left, under 'Advenced Import Options' select a 'Model Type' to change the software workflow:
- Sectioned Model
- default workflow, in which every element is acquired separately and all the information gets merged at the end
- Impression Scan
- if the Impression Scan Module is enabled in the license, check this option to scan an impression and not a stone model
- Concept Quad
- if the Concept Quad Scan Module is enabled, it is possible to scan all the parts of a Quadrant Trye in just one step
- Unsectioned Model
- enable this option if the model to be scanned is not sectioned, the scanner will not require a separate scan for every die
On the right, there are 2 buttons:
Start Project - Creates a specific Scan Project using data coming from the Invoking Sofware, with the selected options, and starts the Step-By-Step Wizard
Close - Closes the software without starting the project
Direct Launch
This is the Start Screen that appears when launching the software directly
In this case, no project is ready so the software will ask to create a new project or to load a previously created project.
New Free Project - Only present if the Free Module is enabled. It allows to create a project in Free Mode
New Project - Allows to create a Structured Project and start a Step-By-Step Wizard
Load Project - Allows to load a previous project
- Close
- Closes the software without starting the project
