Difference between revisions of "Pc Connection/zh-hant"

From Open Tech Dental Wiki 4.0
Jump to: navigation, search
(Created page with "連接電腦")
 
(Created page with "== 連接掃描儀 ==")
Line 2: Line 2:
 
{{DISPLAYTITLE:Scanner's connection|noerror}}
 
{{DISPLAYTITLE:Scanner's connection|noerror}}
  
== Connect the Scanner ==   
+
== 連接掃描儀 ==   
  
 
As you can see in the following pictures, on the back of the scanner there are, from left to right, the
 
As you can see in the following pictures, on the back of the scanner there are, from left to right, the

Revision as of 07:08, 18 January 2016


連接掃描儀

As you can see in the following pictures, on the back of the scanner there are, from left to right, the power switch, the power cable port, the HDMI port and the USB port:

Big.png

Scanner's connection Big/Deluxe

Small.png

Scanner's connection Small

The power cable is an average 230V cable and must be connected to a power line that can hold such voltage in all phases of work and that is protected from overloads and short-circuits.
The HDMI cable must be connected to the Computer, in the Graphic Card's HDMI port. The location of this port in the computer may vary according to the Computer's brand and model. In the Computers we provide, Dell's Alienware i5 and i7, this HDMI port is on the bottom-left side:

Pc.png

The connection of the USB cable depends on the model of the scanner, as in the Easy and Smart models (both Small and Big) there are USB 2.0 components, whereas in the Deluxe model there are USB 3.0 components. Therefore, the USB cable of Easy and Smart Scanners must be plugged in a port USB 2.0 and the USB cable of the Deluxe model must be connected to a port USB 3.0. These ports are usually colour-coded, so it's possible to recognise the 2.0 because of its black colour and the 3.0 because of its blue colour. The USB cable that Open Technologies provides to connect the scanner to the Computer is a 3.0 USB cable (blue), however the above-mentioned instructions remain valid and even though the cable is 3.0, if the scanner is an Easy or Smart model it must be plugged in a USB 2.0.