Difference between revisions of "Pc Connection/ru"

From Open Tech Dental Wiki 4.0
Jump to: navigation, search
(Created page with "''Подсоединение сканера Big/Deluxe''")
(Created page with "''Подключение сканера Small''")
Line 12: Line 12:
 
{{Big image|Small.png}}
 
{{Big image|Small.png}}
  
''Scanner's connection Small''
+
''Подключение сканера Small''
  
 
The power cable is an average 230V cable and must be connected to a power line that
 
The power cable is an average 230V cable and must be connected to a power line that

Revision as of 14:07, 9 February 2016


Подсоединить сканер

Как указано на картинках, на оборотной стороне сканера, слева направо, расположены выключатель питания, разъем питания, порт HDMI и порт USB:

Big.png

Подсоединение сканера Big/Deluxe

Small.png

Подключение сканера Small

The power cable is an average 230V cable and must be connected to a power line that can hold such voltage in all phases of work and that is protected from overloads and short-circuits.
The HDMI cable must be connected to the Computer, in the Graphic Card's HDMI port. The location of this port in the computer may vary according to the Computer's brand and model. In the Computers we provide, Dell's Alienware i5 and i7, this HDMI port is on the bottom-left side:

Pc.png

The connection of the USB cable depends on the model of the scanner, as in the Easy and Smart models (both Small and Big) there are USB 2.0 components, whereas in the Deluxe model there are USB 3.0 components. Therefore, the USB cable of Easy and Smart Scanners must be plugged in a port USB 2.0 and the USB cable of the Deluxe model must be connected to a port USB 3.0. These ports are usually colour-coded, so it's possible to recognise the 2.0 because of its black colour and the 3.0 because of its blue colour. The USB cable that Open Technologies provides to connect the scanner to the Computer is a 3.0 USB cable (blue), however the above-mentioned instructions remain valid and even though the cable is 3.0, if the scanner is an Easy or Smart model it must be plugged in a USB 2.0.