Accessories

From Open Tech Dental Wiki 4.0
Revision as of 10:24, 25 January 2016 by FrancescoMRomano (talk | contribs) (Created page with ";Es ist wichtig, den Modellhalter sauber und schwarz zu halten, um Störungen und Interferenzen zwischen dem Halter und dem Gegenstand beim Scan zu verhindern.")
Jump to: navigation, search


Zubehör

Die Ausstattung der Open Technologies-Scanner beinhaltet Basiszubehörteile. Extra Zubehörteile sind je nach Scannermodell verfügbar.

Grundkit

Das Grundkit wird mit jedem Scanner in einem kleinen Koffer geliefert. Es besteht aus einem Modellhalter, einem Multi-Die-Halter und einer Kalibrierungsplatte.

Modellhalter

Der Modellhalter dient zur Einfügung des Zahnbogenmodells in den Scanner. Bei der Verwendung stellt er die optimale Position des Modells für den Scan sicher.

Es ist wichtig, den Modellhalter sauber und schwarz zu halten, um Störungen und Interferenzen zwischen dem Halter und dem Gegenstand beim Scan zu verhindern.

Model holder big.png Model holder small.png

Multi-Die Support

The Multi-Die support is used to acquire multiple stumps with a single acquisition. The position are later automatically identified by the software.

It's important to keep the Multi-Die clean and black to reduce the possible interferences between the Multi-Die and the object during the acquisition phase.

Model multidie big.png Model multidie small.png

Calibration Kit

The Calibration Kit is a planar surface with a pattern of circles, placed on a bended support.
Every calibration kit is measured and analized with high-precision machines.
The measurement is then saved on a xml file and every kit has it's own xml description file.
The kit is used to recalibrate the optical head of the scanner.

It's really important to handle the kit with care and to avoid touching the planar surface. Every modification of the planar surface, like scratches or dirt, can make the calibration system unreliable.

Calibration kit.jpg

Dynamic Articulation Module

In order to use the dynamic articulation module, some special supports are needed: a specific Axis Calibration Object and a special Mounting Plate for every supported articulator.

Mounting Plates

Up to the present, our dynamic articulation module supports 4 different mounting plates.

  • Artex : Basetta artex.jpg
  • Kavo : Basetta cavo.jpg
  • Adesso : Basetta adesso.jpg
  • Sam : Basetta sam.jpg

Axis Calibration Object

This is a specific object, which fits on every mounting plate, used to calibrate the movement system for the Dynamic Articulation Module.

It's important to keep the object clean and handle it with care. Every modification of the object surface, like scratches or dirt, can make the calibration system unreliable.

Kavo oggettotest.jpg