Accessories

= Accesorii =

Scanerele Open Technologies au un set fix de accesorii de bază și unele accesorii suplimentare care depind de modelul specific de scaner.

Kit de bază

Kitul de bază este livrat împreună cu fiecare scaner, interiorul carcasei conține suportul modelului, suportul multi-die și setul de calibrare.

Model Holder

Model holder este suportul principal pe care plasați modelele sau alte obiecte în interiorul scanerului. Dacă sunt montate pe acest suport, modelele au cea mai bună poziție posibilă pentru achiziția scanerului.

Este important să păstrați suportul modelului curat și negru pentru a reduce eventualele interferențe dintre suportul modelului și obiect în timpul fazei de achiziție.

The tall model holder is provided for Smart Big and Deluxe models, however if the models are prepared to be mounted on a Articulator they might be too tall to be scanned on that support. For this reason, the model holder base can be detached from the plate itself to allow the user to scan taller models on the low support.

Multi-Die Support

The Multi-Die support is used to acquire multiple stumps with a single acquisition. The position are later automatically identified by the software.

It's important to keep the Multi-Die clean and black to reduce the possible interferences between the Multi-Die and the object during the acquisition phase.

Calibration Kit

The Calibration Kit is a planar surface with a pattern of circles, placed on a bended support.
Every calibration kit is measured and analized with high-precision machines.
The measurement is then saved on a xml file and every kit has it's own xml description file.
The kit is used to recalibrate the optical head of the scanner.

It's really important to handle the kit with care and to avoid touching the planar surface. Every modification of the planar surface, like scratches or dirt, can make the calibration system unreliable.

Dynamic Articulation Module

In order to use the dynamic articulation module, some special supports are needed: a specific Axis Calibration Object and a special Mounting Plate for every supported articulator.

Mounting Plates

Up to the present, our dynamic articulation module supports 4 different mounting plates.

• Artex :
• Kavo :
• Adesso :
• Sam :
• Bioart :
• Denar :

Axis Calibration Object

This is a specific object, which fits on every mounting plate, used to calibrate the movement system for the Dynamic Articulation Module.

It's important to keep the object clean and handle it with care. Every modification of the object surface, like scratches or dirt, can make the calibration system unreliable.

Concept Quad Support

The Concept Quad Support is provided together with the additional Concept Quad Scanning Module and it allows to place two antagonist quadrant models and their stumps in the scanner to be scanned in together at the same time.

It's important to keep the model holder clean and black to reduce the possible interferences between the model holder and the object during the acquisition phase.