Wizard Alignment

From Open Tech Dental Wiki 4.0
Revision as of 09:26, 3 February 2016 by FrancescoMRomano (talk | contribs) (Created page with "== Positionsüberprüfung ==")
Jump to: navigation, search


Ausrichtung

Nach jedem Scan richtet der Wizard das neue Objekt am Rest des Projekts automatisch aus.

Wenn ein Objekt nicht automatisch ausgerichtet werden kann, startet die Software den manuellen Ausrichtungsmodus.

Positionsüberprüfung

The automatic alignment system can sometimes compute the wrong position of an object.
For this reason, after every stump and articulator alignment, an Alignment Check step will allow to:

  1. Click Next to confirm the position and continue with the Wizard
  2. Click Manual Alignment to enter the Manual Alignment mode and correct the position

Dental 2 5 wizAlignCheck.jpg

Dental 2 5 wiz prev.png Homebutton.png Dental 2 5 wiz next.png