Wizard Acquisition
Achiziționarea Wizard =
În timpul Wizard pas cu pas, este posibil să: achiziționați obiecte unice sau mai multe obiecte într-o singură scanare, să re-achiziționați un obiect achiziționat anterior și să integrați toate aceste achiziții.
Contents
Obiect unic
De fiecare dată când un element trebuie achizitionat, se va afișa un anumit ecran expert:
- The name of the object to be acquired
- A brief description of what should be scanned
- A selector for the Object Colour
- A Scan Button to start the acquisition
- An Integrate Button to start the integration of a previously acquired object
- An Already Aligned check that shows if this object is already aligned to the rest of the project
It's very easy to follow the wizard:
- Read the object description
- Put the right object inside the scanner
- Click Scan
- If the acquisition is not satisfactory, click again the Scan button to start a new acquisition, or the Integrate button to add data
Open Live
It is possible to open the live view of the cameras, by clickin on the 
to see the progress of the scanning in the monitor of the computer.
Advanced Parameters
During the wizard the acquisition strategy is selcted automatically depending on the kind of element to acquire.
There are some specific cases, however, in which it might be necessary to change the scanning strategy to a non default one. For instance, if the user needs to scan abutments instead of stumps, it would be best to select the specific abutment strategy. Same goes if the user needs to design a veneer: it is not a default strategy for stumps but it can be selected during acquisition.
To change strategy, click on the 
button and select it from the drop down menu.
Copy From Reference
Sometimes, one element data has already been scanned during another acquisition.
In these cases, the software will show the existing image and automatically remove the parts already scanned in detail. It is always anyways possible to copy the whole image again by clicking Copy From Reference or to start a new acquisition if the cut copy is not satisfying.
Multi Acquisition
When acquiring multiple dies or multiple implants, it's better not to carry out a single acquisition for every element.
It is possible to acquire many objects at once.
Just make sure that the objects are completely visible in all their parts and that they are at an adequate distance either on the model holder or on the Multi-Die support.
In these cases, the software will show a Multi-Acquisition Setup step where it is possible to select the objects to be scanned at the same time.
This step will show a list of all the objects that have to be scanned together with the already acquired items. Flag the boxes of the objects that have to be scanned together and, when scanning stumps,the flag Use Multi-Die support option on the bottom of the dialog will be checked by default to allow the use of the Multi-Die holder.
With Multi-Die
If the Multi-Die option is selected, the software will set up a specific acquisition for the dies; an image will guide the user in positioning the dies in the Multi-Die holder.
After the acquisition, the software will automatically recognize each single die and return to the Multi-Acquisition Step to allow the acquisition of additional objects.
Without Multi-Die
If the Multi-Die gets deselected, the software will acquire the objects and, in the following step, require the user to manually identify each object.
A specific Wizard Step will ask which object has to be identified. The user has to:
- Read from the Wizard Page which object has to be selected
- Select the specific object, using a Selection Tool
- Click the button Segment
- Click the button Next
When the objects are all identified, the software returns to the Multi-Acquisition step. If all the objects have already been aquired, click Next to continue with the Step-By-Step Wizard
Integration
By clicking the Integrate button after an acquisition, the Integration mode will be launched.
