Accessories/zh-hant

配件

Open Technologies的掃描儀有一套固定的基本配件和一些隨掃描儀型號而定的額外配件.

基本套裝

基本套裝跟隨每一個掃描儀,在這個手提箱中包含:一個模型支架,一個多代型支架和一個校正組件.

模型支架

模型支架是在掃描儀上放置頜或其它物體的主要支撐物.如果安裝在該支架上，該對象將保證在掃描儀採集的最佳位置。

重點

保持模型支架的清潔和黑色，以减少模型支架和對象在採集階段時可能的干擾。

多代型支持

The Multi-Die support is used to acquire multiple stumps with a single acquisition. The position are later automatically identified by the software.

It's important to keep the Multi-Die clean and black to reduce the possible interferences between the Multi-Die and the object during the acquisition phase.

Calibration Kit

The Calibration Kit is a planar surface with a pattern of circles, placed on a bended support.
Every calibration kit is measured and analized with high-precision machines.
The measurement is then saved on a xml file and every kit has it's own xml description file.
The kit is used to recalibrate the optical head of the scanner.

It's really important to handle the kit with care and to avoid touching the planar surface. Every modification of the planar surface, like scratches or dirt, can make the calibration system unreliable.

Dynamic Articulation Module

In order to use the dynamic articulation module, some special supports are needed: a specific Axis Calibration Object and a special Mounting Plate for every supported articulator.

Mounting Plates

Up to the present, our dynamic articulation module supports 4 different mounting plates.

• Artex :
• Kavo :
• Adesso :
• Sam :

Axis Calibration Object

This is a specific object, which fits on every mounting plate, used to calibrate the movement system for the Dynamic Articulation Module.

It's important to keep the object clean and handle it with care. Every modification of the object surface, like scratches or dirt, can make the calibration system unreliable.